Breg Walker Genesis 4 Straps - Small

Breg genesis walker is designed with built-in air pump.

Durable and has hard shell design for long lasting usage.

Helps in pressure offloading.

Designed with trim-able shell and narrow heel width.

Genesis walker with dynamic air stride technology

Breg genesis walker is a lightest full shell pneumatic walker with dual air chambers.

It has been computer engineered to provide strength where required while eliminating extra weight.

Inspired by athletic shoe design technology, Genesis walker provides a biomechanical and natural walk.

A walker boot that mimics a normal shoe and healthy gait, allowing you to recover with minimal disruption to your daily life.

Beneficial in ankle sprains and strains, forefoot sprains, stable foot fractures and distal tibial fractures.

Loosen all of the straps. Detach the plastic anterior plate.

Open the foam boot cuffs so that it is easy to insert the foot and calf inside.

Place foot into the foam boot so that the heel sits securely against the back of the boot. Make sure the foot is flat on the innersole.

Starting with the foot section of the foam boot, fit the boot by overlapping the cuffs.

One side has a hook closure that will attach over the opposite side.

First, pull the non-hook side of the cuff over the foot, then pull the hook side over and secure when desired fit is achieved.

Repeat the process for the calf section of the foam boot.

Re-attach the plastic anterior shell. There are hook and loop spots on the back to adhere the shell to the foam boot. Place the shell so the top is aligned with the top of the foam boot.

Secure the strap on the top of the foot section first. Insert the strap end through the black D-ring and pull to the desired tension on the strap.

Next, secure the bottom calf strap. Insert the strap end through the black D-ring and pull to the desired tension on the strap.

Repeat the process for the top calf strap.

On the four strap configuration, secure bottom calf strap.

Repeat the process for the middle and top calf straps.

Push the air pump to inflate the air bladder to the desired patient comfort and support. The fitting process is complete.

To deflate the air bladders, press firmly on the release valve until air has been released.

For single patient use.

Should be used under the advice of a healthcare practitioner.

Activity modification and proper rehabilitation are an essential part of a safe treatment program.

If any additional pain or other symptoms occur while using this device, discontinue use and seek medical attention.

The device will not prevent or reduce all injuries.

Carefully read fitting instructions and warning prior to use.

To ensure proper performance of the brace, follow all instructions.

Failure to properly position the brace and fasten each strap will compromise performance and comfort.

Don’t wear it too tight.

Keep out of reach of children.