Breg Z-12 D Combined Instability Brace Small
Brand: Visit BREG Store
Estimated delivery: 6-9 business days
Available Options
Product Highlights
- Z-12 D is designed to provide dynamic control.
- Lightweight brace is ideal for patients of shorter stature.
- Ideal to be used for knee ligament injuries / deficiencies.
- Quick-release buckles for easy application and removal.
Additional offers
Get an Additional 1% off on this order if you Prepay it. Applicable on a min cart value of ₹599. Get cashback up to Rs. 300 on payments via Mobikwik Wallet. For Celergen capsules and serum, please contact Cureka Support directly to place the orders. Contact Cureka support at care@cureka.com or WhatsApp at +919655928004.COD available from ₹599 till ₹9999
MRP: Offer: 43,447.00You Save: 2,553.00 Inclusive of all taxes
- Description
- Additional information
Description
- Z-12 D is featured with a unique hinge-to-strapping system in a dual upright frame.
- The frame contains spring steel reinforcement for extra shell strength.
- Pivoting gastroc strap design helps minimize brace migration.
- Sport models are available with Hi-activity pads and D-rings.
- Hi-activity pads feature an extra-grip material to assist in fit and suspension for impact activities.
Size Chart
| Size | ThighÂ
Circumference |
Standard Calf Circumference | Athletic Calf Circumference |
| XS | 13.5 – 16 inches
(34 – 41 cm) |
12.5 – 14 inches
(32 – 36 cm) |
11 – 12.5 inches
(28 – 32 cm) |
| S | 16 – 18.75 inches
(41 – 48 cm) |
14 – 15.5 inches
(36 – 39 cm) |
12.4 – 14 inches
(32 – 36 cm) |
| M | 18.75 – 21.5 inches
(48 – 55 cm) |
15.5 – 17 inches
(39 – 43 cm) |
14 – 15.5 inches
(36 – 39 cm) |
| L | 21.5 – 24.25 inches
(55 – 62 cm) |
17 – 18.5 inches
(43 – 47 cm) |
15.5 – 17 inches
(39 – 43 cm) |
| XL | 24.25 – 27 inches
(62 – 69 cm) |
18.5 – 20 inches
(47 – 51 cm) |
17 – 18.5 inches
(43 – 47 cm) |
| XXL | 27 – 29.5 inches
(69 – 75 cm) |
20 – 21 inches
(51 – 53 cm) |
18.5 – 20 inches
(47 – 51 cm) |
Direction of Use
- Refer enclosed manual for pictorial representation.
- Unfasten buckles: Release all four straps on the back side of the brace by squeezing the gray levers on either side of the buckle and withdrawing the over-center buckle. Loosen the front straps.
- Position the brace: With the knee bent at 45°, lay the brace on the leg and align the hinge as shown above. Position the center of the hinge on an imaginary line that goes across the top of the knee cap. Push the hinges posteriorly until the hinges are in the center of the knee joint when viewed from the side.
- Anchor the brace: Wrap the upper rear calf strap around the calf as high as possible over the calf muscle. Insert the over-center tab into the base. Push the tab until you hear the hinge click on both sides.
- Adjust the strap by releasing the tab and pull the strap until a snug and comfortable fit is achieved. All straps have additional length adjustment at the opposite end of each strap. (Z-12-D version: Feed the tab end of the strap through the D-ring. Tension the strap until a snug and comfortable fit is achieved).
- Fasten lower calf strap: Insert the over-center tab into the buckle base on the lower calf shell of the brace. Push the tab in until both sides click locked. Adjust strap until a comfortable fit is achieved. (If the strap tab reaches its limit without achieving the desired fit, see next step for adjustment instructions). Center the strap pad.
- Adjust strap length: All straps have additional length adjustment at the end opposite the tab. Release the strap and adjust the length of the strap using the hook and loop fastener.
- Fasten rear thigh straps: Following the same instructions as in Step 4, fasten the lower and then upper rear thigh strap.
- Adjust front tibia strap: Tighten the front tibia strap. If the strap overlaps too far, see Step 6 for adjustment instructions. Center the strap pad.
- Adjust front thigh strap (PCL / Combined instability versions): Tighten the front thigh strap. (Note: Over tightening the front thigh strap can cause the brace not to function properly.) Stand up and walk or jog around to see how your new Z-12 brace feels.
- Straps should not be so tight that blood circulation is restricted. Re-adjust as needed. If this is your first time to wear a functional knee brace, it might take a few hours of wear to get used to how it feels.
- Adjust OA condyle pad: Press down on gray tab and slide into position for desired unloading. Adjust for comfort.
Safety Information
- Carefully read fitting instructions and warnings prior to use.
- To ensure proper performance of the brace, follow all instructions. Failure to properly position the brace and fasten each strap will compromise performance and comfort.
- For single patient use only.
- If you experience increased pain, swelling, skin irritation, or any adverse reactions while using this product, immediately consult your medical professional.
- This device will not prevent or reduce all injuries.
- Keep out of reach of children.
- Consult your health care professional regarding safe and appropriate activity level while wearing this device.
- Care and cleaning of this product is essential to its continuing strength and performance.
- Follow removal and cleaning process described in instructions.
- It is important to keep the brace clean to maintain proper brace function.
FAQ
Yes. Breg Z-12 D combined instability brace can help with meniscus instability, knee ligament injuries / deficiencies.
Meniscus instability or torn meniscus is often caused by a twisting movement of the knee while bearing weight. It causes pain, locking, or clicking, and weakness of the knee.
Breg Z-12 D is available in 6 different sizes such as XS, S, M, L, XL and XXL; refer size chart and choose accordingly.
Yes. It is important to keep the brace clean to maintain proper brace function. Care and cleaning of this product is essential to its continuing strength and performance.
Straps of the Breg Z-12 D should be tight, but not be so tight that blood circulation is restricted. Re-adjust as needed. If this is your first time to wear a functional knee brace, it might take a few hours of wear to get used to how it feels.
Additional information
| Weight | 1.41 kg |
|---|---|
| Dimensions | 26 × 14.5 × 12 cm |
| Manufacturer Details | Breg Inc. 2382 Faraday Avenue Suite 300. Carlsbad Ca 92008 |
| Packer Details | Wedjat Health Solutions Pvt. Ltd. P.NO. 547 F1-F2 Pinnacle Apartment Arul Nagar East Tambaram Chennai Tamil Nadu 600059 Mail: info@cureka.com Telephone no: 9655928004 |
| Components | Brace |
| Country of Origin | USA |
| Expires on or After | 25-04-26 |
| SKU | PAI/BRE/08914 |
